SEAL Image 600-C Instruções de Operação descarregar pdf (Página 10)

Safety Features

Emergency stop buttons

There are two Emergency Stop buttons and they are located on top of the right and left cabinets of

the laminator. They stop the rotation of the rollers and should only be used in case of an

emergency.

Emergency stop trip wire

One emergency stop trip wire is located at the front side close to the bottom side of the laminator.

The switch is installed at the right cabinet. Any touching of the wire stop the rotation of the rollers

and should only be used in case of an emergency.

Opto-electronic protective device

These self-checking photo-eyes prevent foreign objects from passing in between the rollers.

The opto-electronic protective device is set for use in the factory and should not be adjusted except

by a service representative.

Main electrical switch

The main electrical supply “ON/OFF” switch is positioned on the backside of the right cabinet.

Slow (snail) mode by foot pedal

WARNING:

With this feature the

opto-electronic protective device

at the nip point of the rollers

will be temporarily

disengaged

, the rotation of the rollers will

not

stop automatically when human

body parts, clothing, long hair etc. will reach in the nip point.

Press the button to activate the slow mode function, an audible signal will be heard and LED [6]

comes on.

Press the foot pedal, the machine will rotate slowly forward at a fixed speed of 0.5 m/min

(1.6ft/min). The LED [8] will come on.

Release the foot pedal to stop rotation of the rollers.

Press the button again to deactivate the slow mode function.

Locking Cabinets

The cabinets which house the inner workings of the laminator can be opened only with a

screwdriver.

Reset proceed before start of the machine

1. Set the main electrical switch to the “I” (ON) position

2. Rotate the two emergency buttons and pull the blue reset button of the emergency stop trip

wire.

3. Set the speed at 5 and press the start button to rotate the machine until the slow mode LED

comes on flashing for few seconds, the slow mode control is enabled for use now, press the

stop button to stop the rotation.

4. Machine is ready for use now.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 44 45

Comentários a estes Manuais

Sem comentários

SEAL Image 600-C Instruções de Operação Página 10

Comentários a estes Manuais

Manuais e produtos relacionados com Laminadoras SEAL Image 600-C